1.Start with a letter size sheet. Make the starting crease by folding down the top edge but miss the bottom edge by about two or three finger widths. If this gap is either too big or too small, the resulting plane will not fly as well.

2. Make a corner crease by folding down the upper left corner. The left edge of the paper shoudl fall exactly along the edge of the top flap of paper. Unfold this crease after making it tight.

3. Repeat the same fold on the other corner. Make a corner crease by folding down the upper right corner. The right edge of the paper should fall exactly along the edge of the top flap of paper. Unfold this crease after making it tight.

4. Open the sheet to see all the creases created.

5. Refold the large horizontal crease but this time pull in the edges just where the crease meets them. This requires you to reverse the portions of the horizontal crease and the top diagonal crease. Pull all creases down tightly.

6. Reposition the paper so the narrow part is toward the top. Make a new crease by bringing the top edge down but miss the edge of the top layer by about one finger width. This crease should be parallel with the bottom edge.

7. Make another new crease by bringing the top edge down but miss the edge of the previous flap by about one finger width. This crease should also be parallel with the bottom edge. There are many layers of paper now so be sure to press down hard.

8. Turn the paper over and reposition it so that the flaps you just folded are toward the right.

9. Fold the top edge down to the bottom edge dividing the plane exactly in half. Make sure to line up all the edges before making the crease.

10. Reposition the plane so that the new crease is toward the bottom.

11. Make the first main wing crease by bringing down the top edge of the top layer. The new crease should be about one large finger width above the bottom edge and parallel with it.

12. Make another new crease by bringing up the bottom edge of the wing flap you just folded on the last step. The size of this flap is not too critical but the crease should be parallel with the others and the edges should line up.

13. Form down the top triangular layer to form a flap that points downward. The new crease should be parallel to the bottom edge.

14. Turn the plane over from left to right keeping the triangular flap you just folded pointed downward.

15. Fold down the other wing making a crease which exactly matches the one below it.

16. Fold up the bottom edge of the wing just folded down to match the flap created on the other wing. Line up all the edges and try to match the other creases exactly.

17.As before bring down the top layer of the triangle to form a flap which points downward. Try to match the flap beneath it which was created on the other wing.

18. Open the plane and adjust all the angles so they are the same on both sides. Open the small triangular flaps and adjust their angles. The plane is shown here upside down so you can see these flaps. The dihedral angle should be flat or slightly up. Experiment with the angles for different kinds of flights.