a World War 2 paper gun (mp40)
Posted by Paper Airplane Dude | Posted in Paper Airplanes | Posted on 12-12-2010-05-2008
31

(tutorial for this gun is in process)i got to thank NDF211Gunner i got the idea from him ,but this is a mp40 used in the world war 2, once get 1000 veiws i might make tuturial if i have a 5 star rating. (or 4 1/2)
Video Rating: 4 / 5
1. Start with an ordinary sheet of 8 1/2″ x 11″ – 21.6 x 28 cm (USstandard writing paper size). The exact size is not important, it should be rectangular and not square. The paper should be at least 20 Lb. bond or copy paper. 2. Fold over the left hand corner as shown. 3. Crease 4. Result 5. Fold over the right hand corner. 6. Crease 7. Result 8. Carefully close in the sides as shown. 9. Fold down the center line from front to back. 10. Fold the resulting left hand tip up as shown. 11. Crease along the bottom edge. 12. Repeat the same procedure on the right section. 13. Fold the left hand point back. 14. Crease 15. Mirror the same folds on the right panel. 16. Bend the left panel as shown. 17. Crease from back to front only 2/3 of the way. 18. Study photos 18 and 19 carefully. These folds are difficult to describe. Try to duplicate them as shown in the photos. 19. Mirror the folds on the right. 20. Turn the plane over and fold the point back and crease as shown. 21. Turn the plane over again. The result should be similar to the photo. 22. Crease wing as shown. 23. Moisten the crease with your tongue. Do this slowly and carefully or you could receive a painful paper cut on your tongue. 24. Carefully tear off strip of paper. Save the strip of paper because you are going to need it to make the tail. 25. To make the tail, fold down the center of the strip of paper to form a trough. 26. Tear as shown to form control surfaces. The folds should be parallel with the bottom of the …
